16" 5050 Interconnector Cable

The 16" Interconnector Cable for Driverless 5050 LED Light Strips has been created to easily connect 2 Driverless 5050 Light Strips. The interconnector cable is the perfect solution for installation around sharp corners and bends, or even through a wall. The interconnector is 16" in total length, the white center wire is 11" long. To create a waterproof connection on each end of the interconnector cable, the optional Waterproofing glue is required. The interconnector cable ends are made from high grade rigid silicone with UV protection, to help protect the strip and prevent discoloration or corrosion.

To Install: First, put on a pair of disposable gloves as the glue is messy. Then fill each light strip end connector with the optional silicone glue. Take note of the positive and negative wires on the strips and power cord. When connecting make sure the same wires, positive and positive, negative and negative, connect to each other. Take one strip and insert the light strip firmly so the two inner prongs penetrate the light strip and stop. Take a small amount of glue on on your finger and smear it around the entire end connector where the strip was inserted. Repeat this attaching process with the other strip. Recap the glue and place the assembled strip and interconnector out of the way. We recommend leaving the assembly alone for at least 12 hours to dry thoroughly.